Electric heating cables have been recognized by more and more people, and have been applied to all walks of life due to their remarkable effects. Proper technical use can reduce upfront cost investment.
Through the analysis of the following four points, let us understand the rational use of electric heating technology, not only can achieve good anti-freeze insulation effect, but also save a lot of cost.
1. Parameter determination: Before designing the scheme, firstly, it is necessary to accurately understand the use area, occasion, performance characteristics of the heat pipe, tank, equipment and medium, site conditions, etc.; determine the heat tracing demand, technical requirements, local climate, etc. parameter. This is an important design parameter for the correct use of the electric heating cable and the main reference for the correct selection of the model.
2. Correct selection: According to the determination and calculation of the above parameters, the quantity, length, site conditions, explosion-proof, anti-corrosion and temperature requirements of the heating can be obtained; it provides the basis for the correct selection of the electric heating cable model. Correct selection enables the electric heating cable to be rationally utilized and exerts a better performance advantage.
3. Accurate installation: Accurate installation, can better connect to play the heating effect. For example, single or two parallel installations, the electric heating cable is installed at a 45 degree angle below the pipeline; it not only conforms to the principle of heat rise, but also makes the heating cable difficult to soak; the pipe diameter is slightly thick, and the equidistant winding method can be selected. The temperature is even. For specific installation standards, please refer to the technical manual.
4. Do a good job after the event: install the electric heating cable, test it intact, and after meeting the work requirements, add the outer insulation layer. Avoid the failure of the insulation layer after installation and need to remove the rework. After the outer insulation layer is completed, the system is tested again to ensure normal operation.
Correctness is accurately and reasonably utilized, so that the performance advantages of the electric heating cable can be fully utilized. At the same time as the effect is required, it is also possible to achieve safety, energy saving, and low investment.